$40.99
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Mounting a suppressor and hoping it lines up is a gamble nobody should take with a can worth as much as a good rifle. This GrovTec alignment rod takes the guesswork out of it. You slide the rod through your mounted suppressor and down into the bore, then look at how it sits in the end cap. If there's an even gap all the way around the rod, your bore and suppressor are concentric and you're good to send it. If the rod is crowding one side, you've caught a problem before it turned into an expensive lesson.
GrovTec builds this one from ground O1 tool steel with a black oxide finish, so it stays straight and holds up to shop and range abuse. It runs right around 15 inches overall, which gives you the reach to seat into the barrel and pass through the baffle stack on most bolt guns and semi-autos chambered in .308 or 7.62. The rod is sized just under bore diameter on purpose, so it floats freely through a properly aligned setup without dragging.
Baffle strikes are almost always a mounting or muzzle device issue, not bad luck. A rod like this pays for itself the first time you check a new suppressor, a fresh muzzle device, or any combo you haven't fired suppressed yet. Best practice is to rotate the rod slowly as you feed it in, since a concentricity issue sometimes only shows at one clock position, and to check with the can torqued the same way you'd run it live.
The whole test takes under a minute once you own the rod. Drop a bore light in from the chamber end, look through the muzzle end of the can, and confirm the rod is centered with clean, equal spacing. It's a simple habit that protects your barrel, your can, and your peace of mind every time you thread something new together.
It lets you verify that your suppressor's internal bore lines up dead center with your barrel's bore before firing. You insert the rod through the mounted can and into the barrel, then check that the gap around the rod is even all the way around. If it's centered, your setup is concentric and safe to shoot; if it's crowding one side, you've found a misalignment worth fixing first.
It's sized for .308 and 7.62mm bores, so it fits the vast majority of rifles chambered in those calibers along with cans built for that bullet diameter. The rod is intentionally cut a hair under bore diameter so it floats through a properly aligned system without dragging. At roughly 15 inches, it has the length to seat into the barrel and clear the baffle stack on most bolt and semi-auto hosts.
Confirm the firearm is unloaded, mount the suppressor to the torque you'll actually run, then slide the rod through the can and down into the bore. Shine a light down the bore and look through the muzzle end, rotating the rod slowly since a problem can show up at only one clock position. Even spacing around the rod means you're good; contact on one side means stop and sort out the cause before firing.
The ground O1 tool steel and black oxide finish keep the rod straight and durable through repeated use in the shop or at the range, and straightness is the whole point of an alignment tool. A rod that stays true gives you a trustworthy read every time you thread on a new can or muzzle device. Considering what a modern suppressor costs, this is cheap insurance against a baffle strike.
| UPC | 811071013772 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | GTHM364 |
| Color | Black |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.