$34.95
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The stock ejection port cover on most AR-15s is one of those parts nobody thinks about until it starts flopping open or looking beat up. Strike Industries took the humble dust cover and rebuilt it from the ground up in machined billet aluminum, finished in a clean red anodize that adds a pop of color to a matched build. This one is cut for .223 Rem and 5.56 NATO uppers and pulls double duty as both a working part and a cosmetic upgrade.
The big draw here is the quick-detach mechanism. Instead of fighting with the retaining rod and hammering pins the way you do on a mil-spec cover, this one installs or comes off in under ten seconds while the rest of your upper stays put. That means no pulling the handguard just to swap a dust cover, which is a real time saver when you are cleaning or tinkering at the bench.
Strike also built in an adjustable detent set screw so you can dial in the opening power. Receivers wear over time and covers start popping open on their own or getting sticky, so a few turns with a small flathead lets you fine-tune the tension against your specific upper. A little blue thread locker on the ball-detent thread after adjusting keeps that setting locked in.
The patent-pending noise-reduction padding is a nice touch that runs the cover nearly silent when it snaps closed, which matters if you would rather not announce yourself in the field. It also uses a built-in double seal to keep grit, dust, and debris out of the action. The solid billet construction holds up better than polymer over the long haul and gives the whole thing a premium feel.
Worth noting: because this is a billet cover with tighter tolerances, it is a great fit for standard mil-spec and most billet uppers, though it is not made for Aero Precision M4E1 uppers or the Lantac E-BCG due to their carrier and bolt designs. For most AR builds, it drops right in and looks the part.
It is designed for standard mil-spec .223/5.56 AR-15 upper receivers and works with most billet uppers on the market. Keep in mind it is not compatible with Aero Precision M4E1 uppers or the Lantac E-BCG because of their carrier and bolt design. If you are running a standard upper, it should drop right in.
Nope, and that is one of the best parts of the design. The quick-detach mechanism lets you install or pull the cover while the rest of the upper stays intact, usually in under ten seconds. No pounding out the retaining rod like you would with a factory mil-spec cover.
The pads tie into the noise-reduction and sealing system that keeps the cover running nearly silent when it snaps shut. Having spares in the pack means you can replace one if it ever wears out down the road. They are a small detail that makes a noticeable difference in how quietly the cover operates.
There is a set screw that controls how far the ball detent extends, which lets you increase or decrease the opening power. As your receiver wears over time, you can turn the screw with a small flathead to tighten or loosen the fit so the cover behaves the way you want. Strike recommends adding a dab of blue thread locker once you have it dialed in.
| UPC | 708747548501 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | ARBUDC223RED |
| Model | |
| Product Type | Dust Cover |
You must be logged in to post a review.
Reviews
There are no reviews yet.