$16.99
50 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The TacFire Crown muzzle brake is a straightforward, well-built way to take some of the punch out of your .308. It threads onto any 5/8"-24 barrel and uses a crowned port design that pushes exiting gas forward and out to the sides, which cuts down on muzzle rise and lets you settle back onto the target faster between shots. At just over two inches long with a slim 0.87" outer diameter, it keeps a low profile and doesn't add a bunch of bulk or weight to the end of your rifle.
This one is machined from steel and wears a black oxide finish, so it holds up to the heat and pressure that a .308 throws at it. TacFire builds it here in the USA, and the fit and finish match up well with standard AR-10 and bolt gun barrels running the common 5/8"-24 thread pitch. The crowned face is a nice touch too, giving the muzzle a clean, finished look instead of a flat cut.
Folks running this brake have noted it does its job on recoil, and it isn't picky about the platform either. While it's spec'd for .308, shooters have run it happily on 7.62×39 AR builds since the thread pattern lines up. Paired with a decent buffer setup, the reduction in kick makes a real difference during longer range sessions and helps you stay comfortable through a full box of ammo.
Installation is about as simple as muzzle devices get. It ships with a crush washer, so you just thread it on, index it where you want it, and torque it down. If you're stepping up from a plain A2 flash hider or a bare threaded muzzle, this is an easy, budget-friendly upgrade that gives you both better recoil control and a sharper look.
It's threaded 5/8"-24, which is the standard thread pitch for most .308 and AR-10 barrels. As long as your muzzle is cut to 5/8"-24, it will thread right on. That thread pattern also lines up with a lot of 7.62×39 builds, so some shooters run it there as well.
Yes. The crowned port design directs exiting gas forward and outward, which counteracts muzzle rise and softens the felt kick of a .308. The result is a steadier sight picture and quicker follow-up shots compared to a plain A2 flash hider.
It ships with a crush washer, so you have what you need to mount it to a properly threaded barrel. Installation is simple: thread it on, index it straight, and torque it down against the crush washer. Basic hand tools and an armorer's wrench get the job done in a few minutes.
It's machined from steel and finished in black oxide to stand up to the heat and pressure of repeated firing. TacFire manufactures it in the USA. At about two inches long with a slim profile, it stays compact and doesn't add much weight to the muzzle.
| UPC | 811261028647 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | MZ10213B |
| Model | |
| Product Type | Muzzle Brake |
| Shipping Weight | 0.145 |
| Thread Pattern | 5/8"-24 tpi |
You must be logged in to post a review.
Reviews
There are no reviews yet.