Description
Rugged Suppressors builds cans tough enough to earn belt-fed ratings, and this muzzle device is how you put that toughness to work. The M240B muzzle device threads onto the 25/32×24 barrel threads found on M240B pattern machine guns, giving you a proper host interface for Rugged's quick-attach suppressors. It pairs with the Surge762, Razor762, and Micro30, so if you already own one of those cans for your rifles, this is the piece that lets it ride on a belt-fed too.
How the M240B Mount Locks Up
The heart of this device is Rugged's Dual Taper Locking System. Instead of relying on threads alone, the suppressor seats against two machined tapers that wedge tight and center the can on the bore every single time. That means no wobble, no walking loose under sustained fire, and a return to zero you can count on when you pull the suppressor off and put it back on later. On a gun that runs hot and shakes hard, that kind of lockup matters a lot more than it does on a bolt gun.
Built for Belt-Fed Abuse
This is a steel muzzle brake with a matte black finish, measuring right around 3.1 inches long. Rugged rates the Surge762 and Razor762 for belt-fed use, and this mount is the piece that makes that rating usable on an actual M240B host. The brake works fine on its own when the can is off, so you are not stuck swapping hardware between range sessions.
Why Pick the Rugged M240B Muzzle Device
If you have access to a 240 and a compatible Rugged can, this is a simple buy. One mount, torqued on once, and your suppressor moves between hosts in seconds. It is the same dual taper interface Rugged uses across its rifle line, so everything stays consistent with the mounts you may already be running on your other rifles. Simple, stout, and purpose-built, which is exactly what you want bolted to the end of a machine gun.
Key Specifications
- Manufacturer: Rugged Suppressors
- Model: M240B
- Manufacturer Part Number: MD002
- UPC: 859383006594
- Thread Pattern: 25/32×24
- Length: 3.1 in
- Material: Steel
- Finish: Matte Black
- Mounting System: Dual Taper Locking System
- Compatible Suppressors: Rugged Surge762, Razor762, Micro30
What’s Included
- Rugged Suppressors M240B 25/32×24 muzzle device
Frequently Asked Questions
Which suppressors work with the Rugged M240B muzzle device?
It is compatible with Rugged's Surge762, Razor762, and Micro30 suppressors. All three use Rugged's Dual Taper Locking System, so any of them will snap onto this mount the same way they attach to Rugged's other rifle muzzle devices. Suppressors from other brands will not fit this interface.
What firearms use the 25/32×24 thread pattern?
The 25/32×24 thread is the barrel thread found on M240B pattern machine guns, which is exactly what this device is built for. It is not a common thread on standard rifles, so double check your barrel threading before ordering. For typical 5/8×24 or 1/2×28 rifle barrels, Rugged makes separate muzzle devices in those patterns.
Will the suppressor stay tight under sustained belt-fed fire?
That is the whole point of the Dual Taper Locking System. The can wedges onto two machined tapers rather than depending on threads alone, so it stays centered and locked even through heat, vibration, and long strings of fire. It also gives you consistent return to zero when you remove and reattach the suppressor.
Can I leave the M240B muzzle device installed without a suppressor attached?
Yes, it functions as a standalone steel muzzle brake when the can is off. Most people torque it on once and leave it in place permanently, treating it like any other muzzle device. That way the host is always ready for the suppressor whenever you want to run quiet.




Reviews
There are no reviews yet.