$49.95
264 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Breek Arms Warhammer Mod2 takes the tired mil-spec charging handle and gives it a real upgrade without asking much of your wallet. It's a fully ambidextrous unit, so you can grab and rack from either side of the rifle, which is a nice touch whether you shoot lefty, run a support-hand charge, or just want the option. The latches sit at 2.78 inches across with textured grooves cut into them, giving you plenty to hook a finger on even with gloves on.
The whole thing is machined from 7075-T6 aluminum and wears a Type III hard-coat anodized finish in a subtle Magpul-style gray that plays well with a lot of builds. Charging a rifle one-handed can put twisting force on a standard handle over time, and the beefier 7075 build is meant to shrug that off. Weight comes in right around an ounce, so you're not adding anything you'll notice. The latches are deep-set and low profile, which keeps them tucked out of the way of forward-mounted optics and backup sights.
The Mod2 name comes from the reworked gas handling. Breek added relief cuts to the top and bottom of the stem that steer extra gas out the sides instead of straight back at you, and they raised the shelf at the rear to better seal off the back of the upper for anything that does travel straight back. That work pays off most on suppressed setups and gassy builds where blowback in the face is the usual complaint.
Installation is about as easy as it gets. It's a direct drop-in for mil-spec AR-15 and M16 platforms, no tools required, so you can swap it in and get back to shooting in a couple of minutes. For folks looking to make a rifle truly ambi or just tame a little gas, it's a straightforward and reliable pick.
Yes, it's designed as a direct drop-in replacement for any mil-spec AR-15 or M16 upper receiver. No modifications or tools are needed to install it. If your current handle is a standard mil-spec unit, this one will slot right in.
The Mod2 design adds relief cuts on the top and bottom of the stem that redirect excess gas out the sides and away from your face. There's also a raised shelf at the rear to better seal the back of the upper. The benefit is most noticeable on suppressed rifles and gassy builds where blowback tends to be the biggest annoyance.
The latches are wide at 2.78 inches for a solid grip but sit deep and low-profile, so they stay clear of forward-mounted optics and backup sights. The textured grooves give you a firm hold even with large gloves on. It's built to give you leverage without getting in the way of your glass.
It's machined from 7075-T6 aluminum with a Type III hard-coat anodized finish for durability. The stronger 7075 construction is meant to resist the twisting force that can wear out lighter handles during one-handed charging. Breek Arms manufactures these in the United States.
| UPC | 812296030827 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BRK522MGRAY |
| Model | |
| Style | Short |
You must be logged in to post a review.
Reviews
There are no reviews yet.