Description
The ejection port cover spring is one of those tiny AR-15 parts nobody thinks about until it snaps or pings across the garage during a build. LBE Unlimited's AREPS20PK solves that problem in one shot with twenty replacement springs, so you always have a spare within arm's reach instead of putting a project on hold to order a single part. Each one is built to standard mil-spec dimensions and drops into any typical AR-15 dust cover assembly without fuss.
What Sets the AREPS20PK Springs Apart
These are made from 302 stainless steel, which is the right call for a part that lives right at the ejection port and takes a beating from powder residue, weather, and constant flexing every time the cover flips open and closed. Stainless holds up to corrosion better than plain wire and keeps its tension over the long haul, so the cover snaps open and stays put like it should. LBE also manufactures these in the USA, which is a nice bonus for folks who like to keep their parts drawer domestic.
Who Reaches for a 20-Pack of Ejection Port Cover Springs
If you build ARs regularly, run a shop, or just hate being caught short, buying in bulk here makes plain sense. The dust cover spring is notorious for being the trickiest piece of the upper to install, since it has to be wound under tension while you thread the hinge pin through. Having nineteen extras means you can drop one, kink one, or over-twist one and simply grab the next without missing a beat. It's also handy for anyone maintaining a fleet of rifles or refreshing a used upper.
Installation follows the usual AR routine: seat the spring on the hinge pin, wind it a half turn to load tension, rest the legs against the cover and the receiver, then slide the pin the rest of the way and lock it with the C-clip. Close the port, flip it open, and it should snap smartly under spring pressure. These springs pair naturally with LBE's dust cover, hinge pin, and C-clip if you're assembling a complete cover from scratch.
Key Specifications
- Manufacturer: LBE Unlimited
- Manufacturer Part Number: AREPS20PK
- UPC: 706612407540
- Model: AR Parts
- Product Type: Ejection Port Cover Spring
- Platform: AR-15
- Material: 302 Stainless Steel
- Finish: Matte Black
- Specification: Mil-Spec
- Quantity: 20-Pack
- Country of Origin: Made in the USA
What’s Included
- 20 AR-15 ejection port cover springs
Frequently Asked Questions
Will the LBE Unlimited AREPS20PK springs fit my AR-15?
Yes. These are built to standard mil-spec dimensions and work with any typical AR-15 ejection port cover assembly. They serve as a direct replacement for the factory dust cover spring on standard uppers.
Why does the AREPS20PK come as a 20-pack instead of a single spring?
The ejection port cover spring is small, easy to lose, and can get kinked or over-wound during install, so having a stack of spares saves a lot of headaches. It's a smart buy for builders, shops, or anyone maintaining multiple rifles. You get plenty of backups without having to reorder a single part every time one goes missing.
What material are these ejection port cover springs made from?
They're made from 302 stainless steel, which resists corrosion from powder residue and weather while holding its tension over time. That matters for a part that flexes constantly and sits right at the ejection port. LBE also manufactures them in the USA.
How do I install the ejection port cover spring?
Slide the hinge pin partway through the cover and receiver, then set the spring on the pin and wind it about a half turn to load tension. Rest the long leg against the cover and the short leg against the receiver, then push the pin the rest of the way through and secure it with the C-clip. Close and open the cover to confirm it snaps under spring pressure. A slave pin can make the job easier if you have one handy.





Reviews
There are no reviews yet.