Description
The gas tube is one of those small parts that quietly makes or breaks how your rifle runs. This one from CMC Triggers is cut to rifle length at 15.16 inches overall, machined from 304 stainless steel, and finished in black nitride. That nitride treatment does more than look sharp under a handguard. It boosts corrosion resistance, wear resistance, and fatigue strength, which matters a lot for a part that lives right in the heat and pressure path every time you pull the trigger.
Where the CMC Rifle-Length Gas Tube Fits
Rifle-length gas systems run around 15 inches and are typically found on barrels 20 inches and up. If your barrel's gas port is set up for a rifle-length system, this is the tube you want. The longer dwell time on a rifle-length setup tends to give you softer recoil and a slower, smoother cycle compared to carbine or mid-length systems, which is a big reason precision and target builds lean toward it. Just match the tube length to your barrel's gas port location and your handguard, and you're set.
Why the 304 Stainless and Nitride Combo Matters
The gas tube carries hot, high-pressure gas from the gas block back to the bolt carrier group's gas key, and that gas is what cycles the action. Precision machining keeps that flow consistent shot after shot, so the rifle feeds, extracts, and ejects the way it should. The 304 stainless base handles the heat, and the nitride coating adds a hard, slick surface that holds up to fouling and repeated heat cycling over the long haul.
What Ships in the Box
CMC includes the roll pin needed to secure the tube to your gas block, so there's no hunting for extra hardware before your build session. It's made in the USA and backed by CMC's 100% lifetime warranty, which is a nice bit of reassurance for a wear part you'd rather install once and forget about.
Key Specifications
- Manufacturer: CMC Triggers
- Manufacturer Part Number: 81625
- Model: AR-15/AR-10 Gas Tube
- UPC: 859464006345
- Gas System Length: Rifle Length
- Overall Length: 15.16 in
- Material: 304 Stainless Steel
- Finish: Black Nitride Coated
- Color: Black
- Fits: AR-15 / AR-10 with rifle-length gas systems
- Country of Origin: Made in USA
- Warranty: 100% Lifetime Warranty
What’s Included
- Rifle-length gas tube
- Roll pin
Frequently Asked Questions
Will this rifle-length gas tube fit my AR-15 and AR-10?
Yes, this CMC gas tube is made for both AR-15 and AR-10 platforms that use a rifle-length gas system. The key is matching the tube to your barrel's gas port location, which for rifle length is typically on barrels around 20 inches and longer. If your barrel is drilled for a rifle-length setup, this is the correct tube.
How do I know if I need a rifle-length gas tube versus carbine or mid-length?
Gas tube length is dictated by where the gas port sits on your barrel, not personal preference. Rifle-length tubes run about 15 inches and pair with longer barrels and handguards in the 11.5 to 12 inch range. The easiest way to confirm is to measure your existing tube or check your barrel's spec sheet before ordering.
Does this CMC gas tube come with the roll pin?
It does. CMC includes the roll pin that secures the tube to your gas block, so you have the hardware you need to complete the install. Just make sure you have the right punch and a bench block on hand for a clean job.
What's the benefit of the nitride finish on a 304 stainless gas tube?
The nitride coating adds a hard, corrosion-resistant surface on top of the durable 304 stainless base. That helps the tube stand up to the constant heat cycling, pressure, and fouling it sees during firing. It also gives the tube a clean matte black look that hides nicely under a handguard.



Reviews
There are no reviews yet.